Update: iTools and iDisk have been discontinued. Then the destination computer can be used to connect to the same iDisk and move the files over. Once you’ve done it, copy your files from the source computer to the iDisk simply by dragging them over to the Documents Folder. Go to click on the iTools tab, then click on iDisk. How to do it: Owners of OS 9.x can set up an Internet disk, called an iDisk, which comes free with the operating system. Solution: Use Apple’s iDisk to Transfer the Files For a beginner, networking two computers, even Macs, can be intimidating. Your network admin may not approve of your buying a hub and plugging it into the network, but it’ll work fine at home for the cable modem. Then follow the Network File Transfer instructions below.Īdvantage: Allows ethernet to be connected to other devices such as the external network or printer at the same time.ĭisadvantage: There is an initial expense for the hub, although it will most likely be cheaper than buying a new USB floppy drive. (However, make sure you get a different IP address for the second machine!) If you are using a cable modem or a school or office ethernet network, you can plug the uplink port (usually port 1) into the ethernet connection in the wall and let both machines use the intranet and Internet. How to do it: Purchase an inexpensive hub (or an expensive router) and plug both computers into it with standard ethernet cables. Solution: Connect the Two Computers Together via a Hub No Mac prior to 1999 has built-in FireWire, although you can add it to most Power Macs with PCI slots. Could be a permanent connection if you’re not using the Internet.ĭisadvantage: Somewhat complex to set up for the beginner. Then follow the Network File Transfer instructions below.Īdvantage: Cheap – you only need a standard FireWire cable – and very fast. How to do it: If both Macs have FireWire, run a FireWire cable from the FireWire port on one Mac to a FireWire port on the other Mac. Solution: Directly Network the Two Computers Together via FireWire Could be a permanent connection if you’re not using a LocalTalk network or a printer.ĭisadvantage: Somewhat complex to set up for the beginner. Then follow the Network File Transfer instructions below.Īdvantage: Cheap. How to do it: Use an ImageWriter II printer cable between the printer ports on two Macs with those old round Mac serial ports. Most older Macs require a Network Interface Card.) Solution: Directly Network the Two Computers Together via LocalTalk Some older Macs don’t have built-in ethernet. Then follow the Network File Transfer instructions below.Īdvantage: Cheap and fast. Connect the old Mac’s ethernet port to the new Mac’s. How to do it: Buy or build a crossover ethernet cable. Solution: Directly Network the Two Computers Together via Ethernet How to do it: Connect the drive to your new Mac, run the installer program that came with it, and go back to the sneakernet.Īdvantage: Relatively simple and familiar.ĭisadvantage: Relatively large upfront cost, not easily expandable to other users, relies on unreliable floppy disks. Review of File Transfer Solutions Solution: Buy a USB Floppy Drive Many of these solutions should work with Mac OS X, but a lot of specific details are slightly different. Even though Mac OS X 10.0 was available, most users didn’t make the jump until version 1.1, 1.2, or even 1.3. Note: This article was written in the days when Macs still shipped with the Classic Mac OS 9. The solutions below are for individual home and school users as well as small groups such as high school departments. However, since the advent of the iMac, which has no floppy drive, users have had to become more creative. 2001 – Transferring files from one computer to another used to be relatively simple you just copied the files to a floppy and sneaker-netted it over to the other machine, and voilà, you’re done.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |